Mitsubishi P95DW Manual de Instruções descarregar pdf (Página 5)

11. The unit shall be operated only by qualified personnel.

Safety Information

Use high level of precaution against any electrical device. Before connecting

the electrical supply, check to see if the supply voltage is within the range

stated at the rating label, and see to it that the device be seated firmly. Place

the unit in a safe and dry location; it must NOT touch the surrounding. Follow

the safety precautions for chemicals / dangerous materials. If needed, please

contact qualified service representative or ser[email protected]

Environmental Conditions

Ensure the instrument is installed and operated strictly under the following

conditions:

1. Indoor use only

2. ≤95% (non-condensing)

3. 75 kPa – 106 kPa

4. Altitude must not exceed 2000 meters

5. Ambient to 40°C operating temperature

6. Pollution degree: 2

7. Mains supply voltage fluctuations up to ±10% of the normal voltage

Avoiding Electric Shock

Follow the guidelines below to ensure safe operation of the unit.

The scientific camera Image System has been designed to utilize shielded

wires thus minimizing any potential shock hazard to the user. Major Science

recommends against the use of unshielded wires.

To avoid electrical shock:

1. In the event of solution spilling on the instrument, it must be dried out for at least 2

hours and restored to NORMAL CONDITION before each operation.

2. Never connect or disconnect wires loading from the power jacks when the red

indicator light of power switch is on.

3. WAIT at least 5 seconds after stopping a run before handling output leads or any

connected apparatus.

4. ALWAYS make sure that your hands, work area, and instruments are clean and

dry before making any connections or operating the power supply.

5. ONLY connect the power cord to a properly grounded AC outlet.

1 2 3 4 5 6 7 8 9 10 ... 24 25

Sem comentários

Mitsubishi P95DW Manual de Instruções Página 5